New Phantom 3 Pro user. Everything was working fine, connected controller to DJI Go, said updating needed.
The entire P3X_FW_LOG_AB.txt is attached
So, where do I go from here?
- Updated controller without issue.
- Downloaded 1.11.0020 from the DJI site
- Tried updating and it failed (please see attached)
- When I start the remote I am able to link to the aircraft and move the gimbal
- When I connect to DJI Go, I am told aircraft update failed.
- On gimbal
- Green at start up
- Flash Green/Red for about 5 minutes
- Then solid red
- Green near reset if I turn on the controller
- Aircraft Lights
- Back two flashing Green, Yellow, Red, then after about 5 minutes solid red
- Front Two - Solid Red
The entire P3X_FW_LOG_AB.txt is attached
So, where do I go from here?