Phantom 3 PRO crashed NO SIGNAL

[hunch]

ok i know the title says P3Pro but i thought you said at some point this is P3 standard right?

 

[Pedro G.]

ok i know the title says P3Pro but i thought you said at some point this is P3 standard right?

nop, it´s PRO

 

[hunch]

ok then this is your binding procedure.
both, phantom and rc on.
press the small binding button on the phantom for two seconds,
press C1+C2+red record button at the same time, when you hear the rc beep D-DD release the three buttons and
press right silver dial in for two seconds until you hear the remote beep and blue light blinking.
now it's binding

 

[Pedro G.]

ok then this is your binding procedure.
both, phantom and rc on.
press the small binding button on the phantom for two seconds,
press C1+C2+red record button at the same time, when you hear the rc beep D-DD release the three buttons and
press right silver dial in for two seconds until you hear the remote beep and blue light blinking.
now it's binding

done it. but its stays blue and beeping. never changes or goes to green

 

[hunch]

running out of ideas here Pedro

 

[hunch]

ok, let's take one step back here.
check the FW on the controller please. what is it?

 

[Pedro G.]

running out of ideas here Pedro

yeap. I think thats it. Thank you for your patience Hunch. I tell you how it goes

 

[Pedro G.]

ok, let's take one step back here.
check the FW on the controller please. what is it?

I updated the rc today (again). Its 1.6.0

 

[hunch]

and did you do the 1.8.8 on the phantom and it all went smooth?

 

[Pedro G.]

yeap.
it´s ok hunch, we´ve tried. I´ll hope some guy here in town could fix it. (really hope so) I´m still looking for him anyway

 

[hunch]

one last thing..
is the light on the OFDM blinking?

 

[Pedro G.]

sorry, OFDM?

 

[hunch]

on this thing (OFDM) under the bird, one hole the light, the other one is the bind button. is the light blinking?

 

[Pedro G.]

yes, blinking in red

 

[hunch]

and when you press the button next to it then it blinks red/green

 

[Pedro G.]

and when you press the button next to it then it blinks red/green

hi Hunch, and everybody who helped me with this.
After all the strugled I took it to a repair shop and it had broken the sensor that receives the signal of the RC .
I had to replace it (not cheap at all :/ ) and now its flying great
thank you very much for the attention and help

good flights for everyone!!

 

[JonEQuest]

hi Hunch, and everybody who helped me with this.
After all the strugled I took it to a repair shop and it had broken the sensor that receives the signal of the RC .
I had to replace it (not cheap at all :/ ) and now its flying great
thank you very much for the attention and help

good flights for everyone!!

What was bad? My P3P is not connecting and I have no light on the OFDM module.