Phantom 2v+ doesn't see controler after repair

[Nekonny]

After replacing the camera on my 2V+, I was unable to get a response from the quad when trying to start up the motors via the RC.

RC assistant software shows the controller is working just fine, but I get the following on the phantom 2 assistant:

the controller sticks are stuck to 1000.

Something is causing the phantom to be reading the input wrong, or not at all.

Sequence of events and troubleshooting steps:

• Had a crash for unknown reasons (wasn't being observed when it went down, but there were no obstacles in area).
• Observed damaged camera, shell and one engine.
• Replaced shell and engine
• Tested flight ok
• Replaced camera
• Tested Camera; connects and transmits video
• No response from unit when trying to activate engines
• Unplugged camera,
• No response from unit when trying to activate engines
• Reconnected camera
• Ran phantom 2 assistant software; saw screen shown above (control stick reading 1000 on all for variables)
• Ran RC assistant software; Control sticks shown as operating normally
  
• Pressed reset button located on shell of phantom body, turned on controller
  
• No changes in both assistant software.

So in the end, the phantom is getting a reading of 1000 from the controller, but the controller seems to be working just fine. As I was able to test fly it before adding the new camera, I know it was working at some point after the body repair and engine replacement.

Something I also noticed after looking at some forums was to try to bind the controller again. when I first started trying to troubleshoot the problem I did notice an orange light from the reset button, but now I'm not getting any lights from it whatsoever.

I'm strongly starting to feel that its a binding issue, but because I had been able to fly before the camera replacement I didn't see how that could have been.

Would anyone have any suggestions?
Thanks!