Hi everyone,
I had a little crash with my P4P the other day, bent the gimble arm and dented the shell a little (mainly cosmetic). I replaced the yaw arm to fix the VPS error.
While I was at it I went ahead and replaced the shell, before putting the bottom shell back on I threw the battery to test everything out and make sure it was working. No red lights, thought all was good.
After I finished putting the bottom shell on and gimble too. I fired it up and connected to my phone - there pops up ESC error on ALL 4 motors.... HELP! All there is no sound when I start up the drone now, there was before I put the shell on.
Did I fry all 4 motors? Or both ESC boards? Or is it possible that my soldering wasn't connecting the wires well enough.
thanks in advance
I had a little crash with my P4P the other day, bent the gimble arm and dented the shell a little (mainly cosmetic). I replaced the yaw arm to fix the VPS error.
While I was at it I went ahead and replaced the shell, before putting the bottom shell back on I threw the battery to test everything out and make sure it was working. No red lights, thought all was good.
After I finished putting the bottom shell on and gimble too. I fired it up and connected to my phone - there pops up ESC error on ALL 4 motors.... HELP! All there is no sound when I start up the drone now, there was before I put the shell on.
Did I fry all 4 motors? Or both ESC boards? Or is it possible that my soldering wasn't connecting the wires well enough.
thanks in advance