Hi everyone,
I'm in the process of reviving my P2 after a dip in the sea when I was on holiday. It was submerged under about 3 ft of water for about 5 minutes (after having hit a pole next to the water).
I dried it out and ditched the battery. Eventually I cleaned it and the gimbal and the GoPro with contact cleaner and isopropyl alcohol as thoroughly as I could, and when it was dry I switched it on with a new battery. First time, it half-beeped, LEDs went red and something popped and burnt up inside. I found the blown ESC and have replaced it with a new one.
Today after another cleaning session, I started it up again with the top removed. No smoke/burning. Initially, the 4 LEDs were red, and the start up beeps were also okay, but something else was doing this repeated 'be-beep' underneath. Then the LEDs went to green and then only the rear LEDs began flashing amber. Front LEDs were inactive. Beeping/flashing until deactivation.
http://youtu.be/MbkBP8VI1iA
[youtube]http://youtu.be/MbkBP8VI1iA[/youtube]
Other thing I noticed was the OSD mini's little green LED was also flashing.
Gimbal was doing nothing - normally it would be going through its exercises.
Any idea of what is wrong?
Thanks
Reuben
I'm in the process of reviving my P2 after a dip in the sea when I was on holiday. It was submerged under about 3 ft of water for about 5 minutes (after having hit a pole next to the water).
I dried it out and ditched the battery. Eventually I cleaned it and the gimbal and the GoPro with contact cleaner and isopropyl alcohol as thoroughly as I could, and when it was dry I switched it on with a new battery. First time, it half-beeped, LEDs went red and something popped and burnt up inside. I found the blown ESC and have replaced it with a new one.
Today after another cleaning session, I started it up again with the top removed. No smoke/burning. Initially, the 4 LEDs were red, and the start up beeps were also okay, but something else was doing this repeated 'be-beep' underneath. Then the LEDs went to green and then only the rear LEDs began flashing amber. Front LEDs were inactive. Beeping/flashing until deactivation.
http://youtu.be/MbkBP8VI1iA
[youtube]http://youtu.be/MbkBP8VI1iA[/youtube]
Other thing I noticed was the OSD mini's little green LED was also flashing.
Gimbal was doing nothing - normally it would be going through its exercises.
Any idea of what is wrong?
Thanks
Reuben