Making some interesting discoveries. With my P2 and v3.8 of the phantom assistant.
I go to the advanced gimbal tab and watch the signal on my oscilloscope. Basically none of the settings make any observable difference. The gain did not change how fast the pulse width changed, the horizontal limit made no change (as I would have expected) and neither did the vertical limit slider. Though after reading the text I fail to see how a single slider can change the upper AND lower limits. Suspect it is actually changing the mid point rather than the limits.
I could see the pulse width changing properly from 1 to 2 ms as expected.
This includes ticking and unticking the FPV mode. When I tilt the P2 it still changes the signal to maintain the horizon.
Made me think that the settings I were changing were not being updated into the P2. So I repowered the P2 and no change.
I go to the advanced gimbal tab and watch the signal on my oscilloscope. Basically none of the settings make any observable difference. The gain did not change how fast the pulse width changed, the horizontal limit made no change (as I would have expected) and neither did the vertical limit slider. Though after reading the text I fail to see how a single slider can change the upper AND lower limits. Suspect it is actually changing the mid point rather than the limits.
I could see the pulse width changing properly from 1 to 2 ms as expected.
This includes ticking and unticking the FPV mode. When I tilt the P2 it still changes the signal to maintain the horizon.
Made me think that the settings I were changing were not being updated into the P2. So I repowered the P2 and no change.