I crashed my P3 Professional recently and the gimbal was damaged. The gimbal yaw arm broke, and the camera image became intermittent as well. We replaced the broken arm with a gimbal repair kit, and also installed a new ribbon cable. After this, we currently have no gimbal movement at all on power up. There is a green flashing light on the front of the gimbal. Any suggestions are much appreciated.
No Gimbal Movement on P3 Pro
- Thread starter BMDTV
- Start date
Dealing with same. However, the "green" light you're talking about becomes red once my copter is finished with systems check. Installed new yaw arm and ribbon cable. No problems with reassemble. Followed awesome YouTube video. All connections good and straight. DJI cable from DJI. Replacement yaw fits like a glove. Power up and nothing .. no gimbal or camera. No motor/board damage, all covers good/not warped, no dings.
Last edited:
Did you use OEM ribbon cable?
All contacts fully inserted in slots?
The yaw and roll arm motor shafts aligned correctly?
All contacts fully inserted in slots?
The yaw and roll arm motor shafts aligned correctly?
Similar threads
