Did my first calibration this morning and found that the LEDs were going steady green only after the vertical rotation and not as the manual says, "after the horizontal rotation.
After a bit of head scratching I found out why. I was flicking the S1 switch with the aircraft on the ground and then picking the aircraft up to do the calibration. Holding the aircraft at the level it was going to be calibrated at whilst flicking the S1 switch solved the problem immediately....dooooh !
After a bit of head scratching I found out why. I was flicking the S1 switch with the aircraft on the ground and then picking the aircraft up to do the calibration. Holding the aircraft at the level it was going to be calibrated at whilst flicking the S1 switch solved the problem immediately....dooooh !