Hey everyone,
I did not find a clue to this in the forum: I had been getting an error message that the downward sensor needed calibration, so today I finally did a full sensor calibration. After that, when I try to power on the drone I get an error message that says "Navigation System Error Check Redundancy State."
The other thing I had down was run down two batteries from 2.5 bars to one as I will be taking an airline flight Sunday, so the drone also got warm sitting on the table (motors not spinning).
I'm going to let things cool down, do an IMU and compass calibration and try again. In the meantime, does anyone have ideas as to what went wrong? Thanks!
I did not find a clue to this in the forum: I had been getting an error message that the downward sensor needed calibration, so today I finally did a full sensor calibration. After that, when I try to power on the drone I get an error message that says "Navigation System Error Check Redundancy State."
The other thing I had down was run down two batteries from 2.5 bars to one as I will be taking an airline flight Sunday, so the drone also got warm sitting on the table (motors not spinning).
I'm going to let things cool down, do an IMU and compass calibration and try again. In the meantime, does anyone have ideas as to what went wrong? Thanks!