Has anyone had an issue with a previously saved mission after firmware upgrade?
I had a mission programmed to fly up and down my street with about 20 waypoints and 5 focus points. It flew perfectly before the firmware update.
After updating all firmware (also doing IMU, gimbal and compass calibration) on bird and RC, also Go Update, I open FPV and load up that mission and it gets to waypoint 8 and just stops. I can then just push forward on the right stick and it will move in the direction it is facing and I can fly it under my control. I have not touched any switches or anything at this point, all in F mode.
I tried running it multiple times, same result each try?
I had a mission programmed to fly up and down my street with about 20 waypoints and 5 focus points. It flew perfectly before the firmware update.
After updating all firmware (also doing IMU, gimbal and compass calibration) on bird and RC, also Go Update, I open FPV and load up that mission and it gets to waypoint 8 and just stops. I can then just push forward on the right stick and it will move in the direction it is facing and I can fly it under my control. I have not touched any switches or anything at this point, all in F mode.
I tried running it multiple times, same result each try?