Wondered if someone could help, I am newer so learning. I was running a few missions to play with mapping/modeling. I did 2 POI mission via Litchi with my P4P, at 2 diff alt. 1st one was 75ft and 2nd was 125ft, fully around a barn with curves. I set both missions to just auto capture every 2 seconds. I ended up with gaps and I am not sure where the issue is? You can see below the 125ft and it seemed to go fine then paused, for 2 long stretches then a brief one. The other mission also had a few gaps but they were all short. I'd like to avoid this if I can