Hi Folks,
Probably a dumb question but here goes... I just received my Zenmuse H3-3D (I'm upgrading from the 2D) and in the installation video it says to plug the 8 pin connector from the P2 into the anti interference board, then from the other side of the board out to the gimbal correct?
I just called B&H to ask if I needed some extra cables to make this work. They said I may not even need the anti interference board. So, I thought I'd try without it.
The problem I have is I have an FPV setup and I'm using the DJI Hub. The 8 pin cable that comes from the new gimbal doesn't seem to fit on the hub.
Am I missing something? How can I keep the FPV setup I have with the Hub and just add in the new Gimbal?
Many thanks!
Probably a dumb question but here goes... I just received my Zenmuse H3-3D (I'm upgrading from the 2D) and in the installation video it says to plug the 8 pin connector from the P2 into the anti interference board, then from the other side of the board out to the gimbal correct?
I just called B&H to ask if I needed some extra cables to make this work. They said I may not even need the anti interference board. So, I thought I'd try without it.
The problem I have is I have an FPV setup and I'm using the DJI Hub. The 8 pin cable that comes from the new gimbal doesn't seem to fit on the hub.
Am I missing something? How can I keep the FPV setup I have with the Hub and just add in the new Gimbal?
Many thanks!