Hey Fellow Pilots, I have been a pilot flying and repairing Phantoms and Inspires for a long time now, But ran across a issue after re flashing the firmware of a Phantom 2 Vision Plus. After the hard reset, The AC powers on fine and the camera sets up ready for input from the DJI Vision App. However when I tilt the camera in the app, It stays straight down and wont respond to the DJI Vision in the app after that. Total loss of control of the gimbal. All other functions work correctly except this issue. I have tried to find a fix but to no avail. The Assistant software for the P2 after re flash says the gimbal is currant version. Does any one possibly have a solution to this?
Thanks in advance for your response.,, Blue Bird........
Thanks in advance for your response.,, Blue Bird........
Last edited: