Making a post in here. I've been in this thread about a dozen times already before ordering my 3D and have finally had a chance to open my bird and do some recon. Just making it easier for me to find as I plan to do my install in the next few days. I plan on doing a very similar setup to Mr. Ianwood.
I have to rearrange my (large, cumbersome boscam-ts352 w/fan) FPV setup to accommodate the new gimbal so my gimbal mount decision (to drill or not to drill) won't be made until I unsolder/resolder a video cable. I want to get a better video transmitter eventually but I think I just want to take one thing at a time here and get this H3 mounted. It's already been almost two weeks since I've flown and I'm getting antsy!
Anyway. I appreciate all these mounting threads, especially ones as detailed as this.
One thing, since I'm too lazy to search right now . . . Did you update to the latest firmware for both P2 and the gimbal?
I'm still running 1.08 and afraid to update something that's not broken. At the same point, I feel like the latest firmware for both might not be a bad thing since, in theory, the latest should have all the fixes.
Thanks Ian. I'll post again once I'm all set up.
I have to rearrange my (large, cumbersome boscam-ts352 w/fan) FPV setup to accommodate the new gimbal so my gimbal mount decision (to drill or not to drill) won't be made until I unsolder/resolder a video cable. I want to get a better video transmitter eventually but I think I just want to take one thing at a time here and get this H3 mounted. It's already been almost two weeks since I've flown and I'm getting antsy!
Anyway. I appreciate all these mounting threads, especially ones as detailed as this.
One thing, since I'm too lazy to search right now . . . Did you update to the latest firmware for both P2 and the gimbal?
I'm still running 1.08 and afraid to update something that's not broken. At the same point, I feel like the latest firmware for both might not be a bad thing since, in theory, the latest should have all the fixes.
Thanks Ian. I'll post again once I'm all set up.