H3-3D DEAD AFTER INSTALLING FIRMWARE UPDATE

I too had a dead h3-3d (does nothing when I power up the phantom, no self test, nothing) it was getting power because its light was green. I was able to short out the 2 points on the gimbal. Then I could only update the firmware using Phantom Assistant V3.0 (wouldnt work on V3.2). With that said I was successful in updating the firmware of the gimbal but it still wont do ANYTHING when I power up the Phantom and now there is a red light on the gimbal. Has anyone else experienced the same issues as me and gotten the gimbal to work? If so how?
 
I finally get the upgrade after the red and yellow light appears but after it says power down and back the green light appears and back to step one.
[following is a missing step in almost all tutorials that kept the green light coming back]

when you get the update ok please power cycle window instruction dont click ok - and leave the cable in. So switch off and back on then click ok - this made all the difference to mine.
I am using a mac.
 

Members online

No members online now.

Forum statistics

Threads
143,066
Messages
1,467,358
Members
104,935
Latest member
Pauos31