GL300F

OzoneTech · Apr 24, 2021

I have a Phantom 4 Pro Plus. I have the GL300E controller that works well which came with it.
I have a second GL300F (bought used) that can link to drone. But will not fire the motors when testing indoors without the props. A no fly zone message shows up. This does not happen when I link it to GL300E. Can any one please help.

Starz · Apr 24, 2021

You mentioned that you bought the f used. Have you checked the stick mode setting?

OzoneTech · Apr 24, 2021

Starz said:
You mentioned that you bought the f used. Have you checked the stick mode setting?

Yes. It is in Mode 2. Further it works fine when I use it with the DJI Flight Simulator.

Starz · Apr 24, 2021

May very well be the NFZ. Your location?
Maybe go for a drive to another spot to check?

OzoneTech · Apr 24, 2021

Starz said:
May very well be the NFZ. Your location?
Maybe go for a drive to another spot to check?

I am located in NFZ. But I should be able to test/ fly indoors in NFZ using the sensors. I can do that with the GL300E RC. Where as I am not able to test AC with the GL300F at the same spot.

Starz · Apr 25, 2021

I don’t think the sensors have any bearing on this issue.

OzoneTech · Apr 25, 2021

Starz said:
I don’t think the sensors have any bearing on this issue.

Yes I agree with you. The sensors are working fine with the GL300E and the AC. Only when I link GL300F the problem arise. Today I have a response from DJI saying they have referred the case to their R&D. I hope they come up with a solution.

Capt KO · Apr 25, 2021

If it gives an option to accept that you know about it click yes and go. Happens at my house because of an unused hilo pad next door. Only does it on 2 of my 5 drones. Enjoy