GL300F

[OzoneTech]

I have a Phantom 4 Pro Plus. I have the GL300E controller that works well which came with it.
I have a second GL300F (bought used) that can link to drone. But will not fire the motors when testing indoors without the props. A no fly zone message shows up. This does not happen when I link it to GL300E. Can any one please help.

 

[Starz]

You mentioned that you bought the f used. Have you checked the stick mode setting?

 

[OzoneTech]

You mentioned that you bought the f used. Have you checked the stick mode setting?

Yes. It is in Mode 2. Further it works fine when I use it with the DJI Flight Simulator.

 

[Starz]

May very well be the NFZ. Your location?
Maybe go for a drive to another spot to check?

 

[OzoneTech]

May very well be the NFZ. Your location?
Maybe go for a drive to another spot to check?

I am located in NFZ. But I should be able to test/ fly indoors in NFZ using the sensors. I can do that with the GL300E RC. Where as I am not able to test AC with the GL300F at the same spot.

 

[Starz]

I don’t think the sensors have any bearing on this issue.

 

[OzoneTech]

I don’t think the sensors have any bearing on this issue.

Yes I agree with you. The sensors are working fine with the GL300E and the AC. Only when I link GL300F the problem arise. Today I have a response from DJI saying they have referred the case to their R&D. I hope they come up with a solution.

 

[Capt KO]

If it gives an option to accept that you know about it click yes and go. Happens at my house because of an unused hilo pad next door. Only does it on 2 of my 5 drones. Enjoy

 

[Starz]

And the little accept click button is very small and hard to see at times.

 

[OzoneTech]

And the little accept click button is very small and hard to see at times.

I have clicked the accept button and have authorization to fly, but the motors won't fire. I am patiently waiting the solution from DJI.

 

[oconnb]

Firmware?

 

[OzoneTech]

Firmware?

GO4 app V 4.3.37

 

[OzoneTech]

GO4 app V 4.3.37

V1.4.1.0

 

[Capt KO]

Try a sticks calibration. Also try both sticks "in" instead of to the outside. It happens sometimes.