Gimbal problem

[FCPhantom]

Hi

I purchase a gimbal from eBay. http://www.ebay.com/itm/151127634210?ss ... 1439.l2649

My problem is:
I instal Gopro on it and power it up. After power up the pitch is ok, but roll is 45 degrees to right and it do not make low frequency voice..
Is there any way to calibrate it?

 

[Gizmo3000]

the problem is.. you bought an Ebay gimbal! :lol:

There's a few threads on here where people discuss setting up and working with them.
but basically you need to connect it to your computer and change the settings.

 

[bmw330vasilis]

i have the same in my V1.1.1

I have also fpv and 2700 gens battery

I put these values and everything works great

try them if you want...

 

[bmw330vasilis]

 

[bmw330vasilis]

 

[bmw330vasilis]

dont forget to calibrate x value on NAZA sofware AFTER you put the values on GIMBAL software!

 

[htownphantom]

Where can you get the gimbal software?
thanks

 

[9Jamie]

GUI: SimpleBGC_GUI_2_2b2.zip
http://www.basecamelectronics.com/downloads/8bit/

CP210x USB to UART Bridge VCP Drivers
http://www.silabs.com/products/mcu/pages/usbtouartbridgevcpdrivers.aspx

The controller firmware cannot be upgraded because it is not an official release.

 

[htownphantom]

GUI: SimpleBGC_GUI_2_2b2.zip
http://www.basecamelectronics.com/downloads/8bit/

CP210x USB to UART Bridge VCP Drivers
http://www.silabs.com/products/mcu/pages/usbtouartbridgevcpdrivers.aspx

The controller firmware cannot be upgraded because it is not an official release.

thank you thank you thank you

 

[dirtdobber903]

It pays to read thru the past threads thanks for this, my follow mode was disabled