Gimbal Hum

[PARK3R]

Hi everyone, new to the forums here and had a question.

Just got my P3A on Wednesday and installed a Gimbal Guard from RC Killers yesterday. After installing the guard I turned it on and started tilting it all around and noticed when the gimbal reaches it's limits it kind of makes a hum sound like it's struggling. So I'm curious if this is normal on a stock setup as I failed to do this type of test before I installed the gimbal guard.

Thanks in advance!

 

[Cacc]

There is normally not a hum. I would take the gimbal guard off and go back to stock to see if it happens. If not, make sure you are installing the new piece correctly.

 

[PARK3R]

I'll try that, it's odd because it seems fine until I really tilt it almost on it's side then the noise starts...almost like a servo that doesn't have it's end points set is the best I can explain it.