Hi Everyone - 1st time posting.
I have a P4 I bought new and I noticed earlier this year the remove would only charge up to 2 blinking lights rather than 4.
I read about some putting a heat gun to the internals but I rathere not have to take that step and I heard others say cheaper to get a new remote.
Well I fould a remote on Ebay - brand new, GL300C which matched the model of my unit. It was advertised as P3 and P4 and with the model numbers
matching I figured I was good. I ordered it - charged it and all seemed well until I tried to link it my Phantom 4. It beeps blue light for 60 seconds and
can't find the P4 after I pushed the link on the P4 also. I tired with my old remote and it links in 1 second. Both have the PSA switch even.
Any ideas of any steps I am missing? Thanks everyone
I have a P4 I bought new and I noticed earlier this year the remove would only charge up to 2 blinking lights rather than 4.
I read about some putting a heat gun to the internals but I rathere not have to take that step and I heard others say cheaper to get a new remote.
Well I fould a remote on Ebay - brand new, GL300C which matched the model of my unit. It was advertised as P3 and P4 and with the model numbers
matching I figured I was good. I ordered it - charged it and all seemed well until I tried to link it my Phantom 4. It beeps blue light for 60 seconds and
can't find the P4 after I pushed the link on the P4 also. I tired with my old remote and it links in 1 second. Both have the PSA switch even.
Any ideas of any steps I am missing? Thanks everyone