CREE Strobon Lights help?
- Thread starter smoke23
- Start date
Here's where I put mine - 2 red in the front and 2 white in the rear. Might get one more white for the very top.
Color does not matter. Just needs to meet faa requirement of visible from at least 3sm. I use HD velcro.
I would say go for 4. One for each side. I started with 2 and when i tested mine at 16,000 feet i could only see the 2 sides that had lights, and not the other two. So i run 4 to be sure.
They are tiny and the velcro holds them secure.
I would say go for 4. One for each side. I started with 2 and when i tested mine at 16,000 feet i could only see the 2 sides that had lights, and not the other two. So i run 4 to be sure.
They are tiny and the velcro holds them secure.
Three should be fine. I normally fly with 4 (1 top, 1 in back just below bottom battery grip, and one on each of the rear motor mounts).
The white cree's are the most visible. I originally had the red cree's and switched over to the white because they are significantly brighter at distance.
I have not had any interference issues using the 4 locations described above.
Pics of my install here:
Flytron Strobe Lights
Nice strobe setup . . I use STROBON as well as CREE both very good in low light, Have you tried just looking at the display arrow (Bottom left) to show orientation of the craft at any distance. . DJI GO4 has it on all versions
ryantrax
Approved Vendor
- Joined
- Jun 22, 2017
- Messages
- 313
- Reaction score
- 133
- Age
- 55
msinger
Approved Vendor
- Joined
- Oct 30, 2014
- Messages
- 32,152
- Reaction score
- 10,911
- Location
- Harrisburg, PA (US)
- Website
- phantomhelp.com
- Joined
- Jun 17, 2018
- Messages
- 9
- Reaction score
- 1
- Age
- 43
The link is not working anymore.
Does anyone know of any vendors that stock these in the UK? I think the shipping cost can be drastically reduced if ordered from the UK.
Similar threads
