Cant control H3-3d. Why?

[snowsnow]

I've installed the H3-3d gimble according to DJIs installatin video but I cant control it with the lever on the back of the transmitter. What's wrong?

 

[MattBW]

I had this problem after updating my firmware, you need to calibrate your remote with RC assistant and also the Phantom assistant too.

 

[snowsnow]

Tried that but to no avail...

 

[snowsnow]

Solved it!

If anyone else have the same problem and finds this thread, do this: Use a thin screwdriver and stick it into the hole marked with an x on the back of the transmitter och press hard. That will connect some stuff inside the transmitter that needs to be connected.

 

[5tr8flv5h]

Went through the same calibration headache recently. The RC and PT2 assistant wouldn't even recognize any movement in the X1 lever. I just opened up my remote to find out that the little extension from the X1 lever doesn't REACH the control on the circuit board! It works fine when I move it directly with the remote open :/

Any advice? Should I contact my retailer and try and get a new remote or is there an easy fix?

 

[Crazykaktus]

Hi

Did you calibrate your X1 switch ? First let me tell you there is a problem with the connecting pin that runs from the lever between the case and the pod that is on the circuit board. USUALLY - and i say , usually .... Opening the controller and liftung the pod slightly from underneath with a small screw driver does the trick... In my case - That solved the issue