Adjust Gain on X1/Gimbal Control?

[james.wedding]

After updating to 3.02, my gimbal has become SUPER sensitive. Moving the stick on the back of the default controller even 1/4 of the way across results in a full 90deg tilt of the gimbal. I have to move it a tap at a time to get something close to a 30-45 degree tilt. I've switched to Naza-M, but I cannot see anyway to tell the gimbal to use the full movement of the stick to tie to the full 90 degrees of the tilt.

Any ideas?

 

[Lenrage]

Do a calibration with the RC assistant then the regular program

 

[james.wedding]

Thanks! I'll give that a whirl. I had forgotten that I did a calibration in the RC piece prior.

 

[idan_estee]

have you tried adjusting the gains on the phantom software? someone told me on version 3.0 you can

 

[sar104]

have you tried adjusting the gains on the phantom software? someone told me on version 3.0 you can

You can, but the problem described isn't a gain issue because the endpoints are obviously wrong. Calibration will fix it.