rc signal lost

Hi! I bought my first drone today, the DJI Phantom 2 Vision+. And after several hours of troubleshooting, i just can't figure out what to do. The DJI Vision app says "System Error" for a minute or two, followed by "RC Signal Lost" and "Phantom Connection Lost". I have followed the guide to set...

After I upgraded firmware on my P4 I get constant strong interference messages every second or two in a place I have rarely had that message before even though I have flown there many times . I also took the P4 straight up above me to 392 ft on that same first flight after update to take a few...

Hi people, I'm new to the Phantom family :). I bought a new P3S from Amazon and I received an used/refurbished product. The bags and boxes were open, the drone had 7 flight logs from one month ago in Germany and even the props were dirty/slightly crashed (!!!). Oh, and I could not activate it...

Hey everyone, So my drone is not even a year old. I've flown it a couple times when I first got it, then it sat around for a few months. When I tried to fly it last month, it said it needed an update until it could fly. Cool, I updated it and I was ready to go. Took it out last week. It...

Not sure not what to do. Just received my P4 back from IFLIGHT TECHNOLOGY CO. This was from a water dunk in Lake Havasu about a month ago. Though DJI would cover but said that if flown over water it would not be covered. Cost $227 to get it fixed. But Now..... after turning on it had...

As you guys know, I was so desperate after 1.6.8 firmware upgrade and I was loosing RC signal within 40m-60m .. But After 1.5 months finally solved it permanently.. Here we go!!! In my method, Basically you need to put 1.6.80 firmware to your RC and also you need to put 1.5.70+ to aircraft...

Having a strange problem. I have 2 phantom 3 professionals. One is the older W323 model and the other is the newer W323B model. Last week I bound the TX from the W323 to the W323B. Just wanted to see if the old TX would give me better range. It did not. But I had no problems binding it...

This morning I decided to test out 2.7k video of the sunrise to see how it compares to my usual 1080P.. I flew my normal practice area that i've done many times before. At about 2700 feet out, i started getting compass-error and she switched into ATTI mode. As it got closer it went back to GPS...

Hi guys, and kudos for a great forum. I've been reading here a while and have gained a lot of knowledge, so I finally had the guts to take my recently acquired P3A for a spin.:D I've been having a couple of flight in some nice, but freezing weather her in Norway, and I'm really loving the P3A...

Hi guys ! Can anyone help me ?! I flown normally one day, the day after, i turned it on, tried to fly, and after 100/150mt RC SIGNAL LOST !!! I tried to change location, maybe there was something there, but nothing, the problem persists ! I've done the imu calibration, re-linked the rc... and...

Hi! I read a lot of topic about this but nothing helped me. So i upgrade the firmware with no problems. In the end of the upgrading the app said restart my aircraft and controller. After that yellow led flashing in the drone and in the app shows "rc signal lost". I try to re link a lot of times...

You must link the remote controller. The firmware update somehow causes the link to fail. 10. How do I link the remote controller? The Phantom 3 Standard is linked to the remote controller by default, and re-linking is only necessary if the remote controller is replaced with a new one, or RC...