gimbal

I have a working P4 camera pulled from a damaged gimbal. It's been tested and everything works. Listed it on eBay with a starting bid of $50 and or buy it now for $80. If you have any questions, email me at [email protected] or message me through eBay. I'm not a fan of the messaging system...

Phantom 4 Pro – Flying Errors with Gimbal Guard I wanted to make you aware of a significant problem that I have seen with my Phantom 4 Pro. I upgraded from the P4 to the Pro, and moved the gimbal guard to it as soon as I received it (It is a standard looking thin, carbon fiber guard). I...

Hey guys! I just unbox my new drone, flew it once, charged the battery, was going to fly it again but then it said the following "Aircraft disconnected, Gimbal Disconnected, Battery Temperature N/A" I have no idea what's going on. Help? The green dot in the gimbal is on.

So I sorted out the rest of the problems with the Phantom 2. Flew it for a while. Charged all the batteries again to a full good charge. Connected the H3-3D with gopro and went to do a test flight. The initial crash occurred with the camera set-up on the P2. It flipped over from about 20 feet...

Looking for a P4P gimbal. I am based in the UK so ideally someone in the UK but I'm open to offers abroad.

So my Phantom 4 Pro took a tumble and the gimbal arm seems to have separated from the motor. At least that's what I think. I don't have DJI Care and I'm looking for some advice as to if I'm correct about it being the arm and motor and if it's something I might be able to fix on my own. Here's...

Hey - I'm selling a mechanically sound but eletrically dead(-ish) Phantom 3 Professional gimbal + camera in case anyone is interested: DJI Phantom 3 Professional Camera and Gimbal for Parts | eBay Feel free to ask any questions.

Anyone know where to find in the dji assistant how to calibrate the gimbal to vision +? I am having problems with the camera after I try and move it up and down with the wheel on the remote. I point the camera down and when I take my finger off the wheel the camera comes back up to center? Any...

I have a question on the Gimbal cushions. I bought my P3P about 9 months ago and have had about 150 flights. Yesterday I flew a mission and had “jerky” video (see ) you will note that the video clears up at about 1:32. It was not very windy (my gust about 10), so I am thinking it is a...

My P3 Standard now needs gimbal calibration every time I start. Plus it is pointing about 5 degrees to the left. Allen screw on horizontal shaft is against flat side. IMU calibration is correct. It did suffer minor crash. Help?

My friend has a phantom 4 pro which crashed and it seemed like only the yaw arm was broken and the flex torn. I bought both new parts on ebay and replaced them and now i can't move the camera anymore. It's just dangling there. The video stream works fine though. When i turn it on, the camera...

I recently crashed and I need a new gimbal motherboard for the advanced any suggestions of where I could get one it would be great. thanks

The other day I encountered some problems with the gimbal while the drone was in the air. Suddenly the camera started pointing down and I couldn't tilt it up with the RC dial tilt button. Got a "gimbal overload" message in DJI-GO. Checked it and noticed that two (the ones without plastic pins)...

Hit a tree limb and the whole thing crashed onto concrete 15feet down. The camera and gimbal separated from the body of the drone. The grey ribbon cable and antenna wires were pulled out fairly cleanly and I was able to piece everything back together with a lot of help from this forum and smart...

I am parting out a Phantom 3 Advanced that has the compass connector broken off the ESC board. Owner tried to open shell and broke it. Drone was flying great prior to him trying to open it up. Powers up and all clear, just gives compass error. 2.7k Camera, Gimbal and mount in excellent shape...

Hello, I'm writing here cause I am desesperate .. A month ago, I had a brutal crash with my P3 4K. Of course the most fragile part of the gimbal broke, the yaw arm and the wire connector. I figured out that I could repair the gimbal and indeed I ordered the parts and eventually re-built the...

Hey guys! I'm new to this thread but I'm trying to sell my P2 with its H3-3d Gimbal already installed however for some reason now when I turn on the device it is stuck at like a 15-degree angle and won't go up any further (here is a picture: H3-3D Gimbal Broken..). I've tried plugging it into my...

Hello, I had to fly in humid conditions (just humid, fog/mist in a rainforest - not heavy rain) and somehow humidity got trapped inside camera. gimbal is acting erratically and i have problem lowering camera down and pulling it up. seems something inside not moving smoothly. additionally, when...

Every time I yaw left or right a horizontal line rises up the recording. I bought this used so no idea of it's crash history. Ive inspected it thoroughly from the outside and there are no marks from a crash, the camera and gimbal look flawless and the ribbons seem to be fully seated.

Hey all, I got some new lens filters and was down at the park testing them out, taking shots to compare to the old filters, etc. Another UAV enthusiast came up to chat. When I brought the craft down and set it on the table to unscrew one filter and screw on another, he asked why I was messing...