Hi guys,
Got my new P2 and H3-3D in last week and got all the firmware updated and everything put together. I've notice that when cycling the X1 slider, the gimble doesn't pan to the max and min. I hooked the P2 back up to the assistant to calibrate it but before I hit start, I saw that when sliding X1back and forth, the "X1 sticks monitor" is behaving "sticky" for lack of a better term. From the left side, only a small control input zips the monitor all the way to the right (even when I've only moved it a fraction of the way on the physical slider.
During calibration, it seems to be more responsive and linear on the monitor, but as soon as I finish calibration, it went back to the previous behavior. Physically, while sliding the X1, the gimbal jumps from straight up to almost pointing down, but it doesn't quite make it flat down. On the way back up, it gets almost facing straight forward (maybe a few degrees shy) and then slowly finishes moving to face forward the rest of the way.
Hopefully this is all making sense.
I'll try to get a quick video of the behavior tonight to better explain what's going on. Has anyone experienced this? I saw in a few posts that the recommendation was to calibrate X1 using the RC assistant first and then the P2 Asssiant after, but my RC assistant doesn't allow me to calibrate X1 (says to use the P2 Assistant) so I'm not sure if I was misunderstanding the fix or what...
Any help would be appreciated.
Got my new P2 and H3-3D in last week and got all the firmware updated and everything put together. I've notice that when cycling the X1 slider, the gimble doesn't pan to the max and min. I hooked the P2 back up to the assistant to calibrate it but before I hit start, I saw that when sliding X1back and forth, the "X1 sticks monitor" is behaving "sticky" for lack of a better term. From the left side, only a small control input zips the monitor all the way to the right (even when I've only moved it a fraction of the way on the physical slider.
During calibration, it seems to be more responsive and linear on the monitor, but as soon as I finish calibration, it went back to the previous behavior. Physically, while sliding the X1, the gimbal jumps from straight up to almost pointing down, but it doesn't quite make it flat down. On the way back up, it gets almost facing straight forward (maybe a few degrees shy) and then slowly finishes moving to face forward the rest of the way.
Hopefully this is all making sense.
I'll try to get a quick video of the behavior tonight to better explain what's going on. Has anyone experienced this? I saw in a few posts that the recommendation was to calibrate X1 using the RC assistant first and then the P2 Asssiant after, but my RC assistant doesn't allow me to calibrate X1 (says to use the P2 Assistant) so I'm not sure if I was misunderstanding the fix or what...
Any help would be appreciated.