Up until today, any video I shot with my P3S (MP4 format), edit and subsequently recreate appears fine when I view it on any 24 in monitor. Hard to tell the difference between the newly created video vs the original from the P3S.
Today, I decided I would load the recreated files into Plex and view them on my (58") big screen TV. The amount of flicker I was seeing in certain spot was quite annoying. My first thought were that this must be because of the props. I then loaded the original file and while it did display some flicker (at the same locations in the video) it was not quite as bad.
To edit/recreate the video I use PowerDirector 13. When I produce the newly edited video I select the following settings:
- H264 AVC
- Mp4 1920 X 1080/30p
or
- MKV 1920 X 1080/60p
In either case, the produced file is half or less the size than the original file.
My questions are:
- Are the above settings the ones I should use or should I use other options when creating the video?
- Is there a way to reduce this flicker?
- Are there better video editing options with cost similar to PD13?
Thanks in advance
Today, I decided I would load the recreated files into Plex and view them on my (58") big screen TV. The amount of flicker I was seeing in certain spot was quite annoying. My first thought were that this must be because of the props. I then loaded the original file and while it did display some flicker (at the same locations in the video) it was not quite as bad.
To edit/recreate the video I use PowerDirector 13. When I produce the newly edited video I select the following settings:
- H264 AVC
- Mp4 1920 X 1080/30p
or
- MKV 1920 X 1080/60p
In either case, the produced file is half or less the size than the original file.
My questions are:
- Are the above settings the ones I should use or should I use other options when creating the video?
- Is there a way to reduce this flicker?
- Are there better video editing options with cost similar to PD13?
Thanks in advance