Hi, does anyone experienced similar problem?
After installation of HDMI output module, there are artefacts in DJI Go which after a short while, almost preventing controlling Phantom drone, because it is not possible to see clear picture from camera. It look like communication over USB is not fast enough to transfer image data. It happen with two Android devices and all usb cables I have, therefore it should not be fault of Android device or cable. Picture displayed on HDMI output is crystal clear whole time, but it is not possible to control all functions using DIY FPV gogles. I doublechecked all flex cables inside transmitter and HDMI module and look like there is no problem there. USB debugging must be turned on, otherwise DJI Go is not able to connect to tramsmitter.
After installation of HDMI output module, there are artefacts in DJI Go which after a short while, almost preventing controlling Phantom drone, because it is not possible to see clear picture from camera. It look like communication over USB is not fast enough to transfer image data. It happen with two Android devices and all usb cables I have, therefore it should not be fault of Android device or cable. Picture displayed on HDMI output is crystal clear whole time, but it is not possible to control all functions using DIY FPV gogles. I doublechecked all flex cables inside transmitter and HDMI module and look like there is no problem there. USB debugging must be turned on, otherwise DJI Go is not able to connect to tramsmitter.