Good day there.
Hope everyone are good as it is my first post here and hope to have a great time on this forum.
I just got the new Turnigy 9xr and trying to make it work on my Phantom2 "Non vision"
As soon as i took the upper shell off the drone, i noticed that there was 2 Wires connected to the receiver of the P2. Now which of them should be connected to the New receiver?
Once all of this is done, how do you bind them?
And what are the procedure to finally have the controller to control the DJI phantom2?
As there is not a lot of information on how to set them up properly
A big thank you to all that can help me around.
Hope everyone are good as it is my first post here and hope to have a great time on this forum.
I just got the new Turnigy 9xr and trying to make it work on my Phantom2 "Non vision"
As soon as i took the upper shell off the drone, i noticed that there was 2 Wires connected to the receiver of the P2. Now which of them should be connected to the New receiver?
Once all of this is done, how do you bind them?
And what are the procedure to finally have the controller to control the DJI phantom2?
As there is not a lot of information on how to set them up properly
A big thank you to all that can help me around.