- Joined
- Jan 1, 2014
- Messages
- 141
- Reaction score
- 0
So I have a phantom 2 vision but I am assuming it the models are similar enough that the issue would apply to either. The problem I am having is when I switch off the controller I have the failsafe set on my frsky x8r receiver to go into failsafe mode and all gimbal sticks go to neutral, which works fine unless I try to turn back on the controller to take back control. The problem is that for a few seconds the three position switch toggles past the GPS setting on the flight controller. I believe this Is causing the P2V to fly out of control for a second until the controller reconnects and then the 3 position toggles to the correct spot and I can regain control. Its not the worse thing in the world because I can just not turn the controller back on and it will return to home and land. however in some cases I may need to retake control and I can see a potential disaster.
Has anyone else experienced this? I also noticed that I get an rx error in the phantom assistant when I first turn on the controller although the controls work just fine. I am thinking this is all part of the same problem. Anyone know for sure?
Thanks~
Has anyone else experienced this? I also noticed that I get an rx error in the phantom assistant when I first turn on the controller although the controls work just fine. I am thinking this is all part of the same problem. Anyone know for sure?
Thanks~