I recently replaced the receiver board inside my phantom because it went out (somehow) I replaced that board with a new one, and the indicator light was working again.
I re-linked the controler with the receiver board, but the motors still will not turn on. The phantom constantly blinks yellow and the transmitter indicator light is off when the controler is on. In the Assistant Software, I cannot run a command sticks calibration. However, I can calibrate the remote in the RC Assistant software. I have reinstalled ALL of the firmware, my battery is charged, and everything appears to be functional. Except the part when I try to take off....
Any advice would be great! Thanks
I re-linked the controler with the receiver board, but the motors still will not turn on. The phantom constantly blinks yellow and the transmitter indicator light is off when the controler is on. In the Assistant Software, I cannot run a command sticks calibration. However, I can calibrate the remote in the RC Assistant software. I have reinstalled ALL of the firmware, my battery is charged, and everything appears to be functional. Except the part when I try to take off....
Any advice would be great! Thanks