KassioLM said:
Have you updated both the control board firmware AND the motor's firmware? And have you also calibrated X1 on your TX in your Naza Asst Software?
Tarot t2d
- Thread starter KassioLM
- Start date
Have you updated both the control board firmware AND the motor's firmware? And have you also calibrated X1 on your TX in your Naza Asst Software?
CarlJ said:
everything is as it should be, updated and configured with gains without vibration the only thing that bothers me is when seto with the knob to -45 to move the phantom when tilting it changes the position of the camera tilt.
exactly as shown in the video below, the of you behave so well? because zenmuze keeps the -45 degrees.
http://www.youtube.com/watch?v=dNQ6C7c82nU&list=UUF8JaHAsC2LjzVnlt8TqUSw&feature=share&index=1
KassioLM said:
Alright damnit, I was trying to avoid this since I was in Nashville filming, but you leave me no choice! And to answer your question my Tarot is working perfectly, but I did have to make a few adjustments in the Naza software and the gimbal software to get everything just the way I wanted. Stay tuned for screen shots of my settings.
And don't you give up on me or I'll drive to your house and fix it myself! :lol:
CarlJ said:
hahah thanks man, but my settings are slightly different in the gimbal gains but what affects most is that my setup is with a Phantom2, software and naza not have more of these options to control the gimbal x1.
KassioLM said:CarlJ said:
hahah thanks man, but my settings are slightly different in the gimbal gains but what affects most is that my setup is with a Phantom2, software and naza not have more of these options to control the gimbal x1.
Friend, solved the problem, I made a downgrade to firmware 1:08 ower possessed these options and changed the setting now gimbal responds perfectly in mode 2 and the camera no longer changes its initial angle. then did the update again to version 3.2 and everything worked perfectly, thanks for the tip ...
Kassio, I just got the adapters that you used and im now trying to install them. How did you? I'm not sure which way it goes. Could you post a close up picture of how you have it setup? Thanks!
You could try these too to mount your Tarot:
Mounting plate for P2: http://www.ebay.co.uk/itm/131453417883
10mm landing gear spacer risers: http://www.ebay.co.uk/itm/131468861055
Last edited:
i download the version 1.08
I get it ..
you must update Main Controller Firmware to new version.
I need to lose phantom firmware ??
how do you do that??
some tutorial?
I get it ..
you must update Main Controller Firmware to new version.
I need to lose phantom firmware ??
how do you do that??
some tutorial?
Similar threads
