Hello All,
bought my 3DPOWER Plug-N Play Brushless Gimbal Mount V3 for FPV DJI Phantom 2 Vision and used a few times.. havent flown in in a few months.
did a calibration, 6 point calibraton but it seems taht when it counteracts, one side seems to stick.
at first i thought my settings were screwey.. so I reset the gimbal to factory settings ( theres a file somewhere that had it) no dice.
then saw this.. one side was touching the housing.
took apart the gimball.. has the heat warped its housing? thinking of shaving a bit on the inside where its touching.
any help/advice is much appreciated. Absolutely love this gimbal.
bought my 3DPOWER Plug-N Play Brushless Gimbal Mount V3 for FPV DJI Phantom 2 Vision and used a few times.. havent flown in in a few months.
did a calibration, 6 point calibraton but it seems taht when it counteracts, one side seems to stick.
at first i thought my settings were screwey.. so I reset the gimbal to factory settings ( theres a file somewhere that had it) no dice.
then saw this.. one side was touching the housing.
took apart the gimball.. has the heat warped its housing? thinking of shaving a bit on the inside where its touching.
any help/advice is much appreciated. Absolutely love this gimbal.
works fine..
