Phantom2 vision w/o gimcal false...

[reednoel4u]

Dear all,
my phantom start up no problem.
and increase throttle without propeller, the all motors spin good.
But, when increase throttle with propeller , the 1st motor will stop.
when increase throttle one more, the quad flip.
Plese help me, how to check and fix with many thanks.
( Please attached link as video)
WIN_20181230_13_57_57_Pro.mp4
video-1546154251.mp4
Thanks and Best regards,
Reed Noel.

 

[Jayfdee]

Sounds like a faulty esc, I had one fail on mine. Easy to replace, but last time I did one for a friend, and found it hard to source a new one. The vision 2 is getting old now.

 

[reednoel4u]

Sounds like a faulty esc, I had one fail on mine. Easy to replace, but last time I did one for a friend, and found it hard to source a new one. The vision 2 is getting old now.

Dear @Jayfdee,
Thanks for your support.
I had some FET of esc phantom2, is this false on FET or firmware ?
Rgs,
Reed.

 

[Jayfdee]

Field Effect Transistor? I have no idea how the esc works.
I doubt a fault due to firmware.
A new esc should be quite cheap, you need to do a bit of soldering, but not hard, it would be my first shot. They do fail quite often.

 

[Mako79]

Have you opened it recently???
If you have, its very highly like the m1-m4 plug on the Naza board is installed upside down.

P2V+ flipping after repair