Since DJI is not replying to my emails and I wouldn't send them my Phantom 3 until the say that they
have a new bottom she'll design that will prevent cracks I'm working on some reinforcement plates for the motor mounts of the Phantom 3.
Not to sure that will actually do any real supporting unless the raised shoulders that go in to the existing screw holes actually bottom out in the existing holes AND it is epoxied in place. But its nice to see someone helping the community rather than trying to profit from it!
Nice try but the UAVBits one has been tested and works great, also as mentioned you need to support the other 2 screws if you go ahead with this. At the moment you could but phantom guards and the detachable bracket would do the same thing.
I had a crash yesterday due to a random / crazy fly away and if it wasn't for the UAV Bits Strongarm and Camera Guard I would have certainly lost the 4K camera and probably the landing gear. I also believe this also prevented the gymbal from separating.
To me the P3 out of the box is super fragile especially with the camera and the shell in terms of cracking.The reinforcements I just mentioned are relatively inexpensive and have already payed off for at least me.
I didn't do it for profit. You can DL the file and find someone local to print them. Plus, the 6 hole version need fitting test. I'll try to do it next week.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.