Hi all,
I just upgraded to the 3.16 firmware as the Naza M Assistant recommended (after first upgrading to Naza M V2) but since doing it my compass wont work properly. I get the red/amber constant LED message no matter what and it won't let me flip the gps/atti switch to enter compass calibration mode.
I tried just doing the gps dance anyway and subsequently found out that the compass seems to work OK (or at least the error message stops) if I invert the Phantom so it is upside down! I also get Error 27 in the Assistant - this goes away if I invert the quad. She flies but she is very twitchy and I need to constantly correct.
I have uploaded a video of the weirdness to YouTube, see here - http://www.youtube.com/watch?v=YnEQ5MfbRe0
Any help would be appreciated, I've put an email to DJI Europe but I'm not holding my breath for a speedy reply.
Cheers
Russ
I just upgraded to the 3.16 firmware as the Naza M Assistant recommended (after first upgrading to Naza M V2) but since doing it my compass wont work properly. I get the red/amber constant LED message no matter what and it won't let me flip the gps/atti switch to enter compass calibration mode.
I tried just doing the gps dance anyway and subsequently found out that the compass seems to work OK (or at least the error message stops) if I invert the Phantom so it is upside down! I also get Error 27 in the Assistant - this goes away if I invert the quad. She flies but she is very twitchy and I need to constantly correct.
I have uploaded a video of the weirdness to YouTube, see here - http://www.youtube.com/watch?v=YnEQ5MfbRe0
Any help would be appreciated, I've put an email to DJI Europe but I'm not holding my breath for a speedy reply.
Cheers
Russ