Phantom 4 Gimbal Facing to the Right

[Mdeblasi1991]

I replaced an ESC that seemed dead (the camera was limp and there were yaw and roll errors in DJIGO4), but the camera is facing to the right after the replacement. Is there any sort of calibration software I can use? I’ve tried the obvious: IMU calibration, compass calibration, firmware refresh, calibration with DJI assistant 2, etc. Any fix for this or is it a bad board? Thanks.

 

[Deleted member 62848]

Here's a picture,,was it set straight inside on assembly ,some screws here loosen to adjust if nothing in app changes it,you might have to drop the gimble again and set straight manually

 

[Deleted member 62848]

Yippy or no yippy,,?there is in your settings adjust gimble yaw but depends how far out it is,,

 

[Mdeblasi1991]

Yippy or no yippy,,?there is in your settings adjust gimble yaw but depends how far out it is,,View attachment 120136View attachment 120137

Yeah, it’s too far out. Thank you though.

 

[Mdeblasi1991]

Yippy or no yippy,,?there is in your settings adjust gimble yaw but depends how far out it is,,View attachment 120136View attachment 120137

Do you know of a way to revive a limp speed controller with yaw and roll errors? The camera moves up and down on startup, but then goes limp.

 

[ArnoldLeVine]

before you take it apart, try the gimbal calibration method I found in this thread

Phantom 4 RTK off centered camera

Hello, I just received a P4P RTK that I am using for work. When I took it out of the box and fired it up I noticed the camera was pointing to the side. I have a P4PV2 and that had the same issue after several flights. On that one I was able to go into the gimbal settings and adjust the...

phantompilots.com