phantom 3 se 5.8Ghz module not present

[cagnuz]

hi, I'm trying to mount external antennas to the drone, I bought antenna elix for the remote control.
and the cloverleaf antennas for the drone, unfortunately on the drone I have only two connectors that start from the gimbal (black and gray) but no connector on the motherboard ... it seems to miss the 5.8 ghz module.
can someone give me explanations?

 

[WV. Rootman]

I know the P3. The black and the grey start at the gimbal and go to 2 round antennas. One on each side of the battery housing.

 

[cagnuz]

No, gray and black in my case go to the antennas in the landing gear, there are no antennas in the battery compartment

 

[Deleted member 62848]

No, gray and black in my case go to the antennas in the landing gear, there are no antennas in the battery compartment

HI I sure the what vw was meaning,this inside batt compartment on p3s,,me put red dot on it

 

[cagnuz]

Is empty

 

[Deleted member 62848]

Cool,,ok me have look and see what I can find,,sorry about that

 

[cagnuz]

Again, I only have two antennas in the landing gear, one gray and one black, connected to the gimbal

 

[Deleted member 62848]

Again, I only have two antennas in the landing gear, one gray and one black, connected to the gimbal

OK I find this, ,,I'm trying to find a decent picture but proving bit tricky,,,I still looking

 

[Deleted member 62848]

OK it seems the antenna is same location as the p3s,single grey wire under this cover which held down with 2 small screws,it clips into board which you will see when cover is off,man its hard to find tear down pictures of this,everything else but

,,,does yours look like this

 

[cagnuz]

Thanks for the info ... I have already disassembled the gimbal, I removed the two original antennas, now I would like to replace them with two cloverleaf ... But at 5.8 Ghz or 2.4 ghz?

 

[Deleted member 62848]

Thanks for the info ... I have already disassembled the gimbal, I removed the two original antennas, now I would like to replace them with two cloverleaf ... But at 5.8 Ghz or 2.4 ghz?

OK I did delete me posts due to me being unsure and don't want to give wrong info to you,
Going to investigate to find the right info I tune back shortly,,,,