Hi Rick - you might be correct about the 0.2 divisions I can't get at it at the moment to look - android is updating. Here we go again, another unknown.
Worst part about it is the app/bird doesn't remember any adjustment you make in this.
I gave DJI chatline a rev up & they said that they would pass it on.
[I am not holding my breath, or flying the 3 for the moment].
The fix for the p2v+3:-
[apart from physically twisting the shaft, in the housing which isn't a good idea, unless you prang it]
is to wire a 50k preset pot across the feedback pot from inside the gimbal, and connect it's wiper via a 470k resistor, to the wiper of the FB pot. Buy some decent [60/40 non lead-free-crap] solder. Mine is stuck onto the back of the gimbal with some DS tape & contact adhesive. I just filed a slot in the bottom of the cover to clear the ribbon cable i used] Mine only needs about 5 deg acw on the 50k preset for level on the pic. Mileage may vary.[disclaimer lol].
Maybe we should wait until DJI sort out the sticky adjustment in their software? I have only flown my p3a a few times. It's a much better beast, with a nicer camera, but at least one legacy fault.
If you do the preset mod, remember to wait at least 5 sec after adjusting - the integral time appears to be set at about that.
peter