- Joined
- Jul 4, 2016
- Messages
- 10
- Reaction score
- 0
- Age
- 40
Hello.
I have repair my gimbal on phantom 3 pro. It was damaged after crash. I bought new mainboard (gimbal) and tape to gimbal.
Everything is ok except gimbal stabilization. It stabilize about 90-95%
When I mount 1 axis (axis from mainboard) to oryginal position - gimbal can't stabilize (left right) - it goes to the maximum left position (it is not straight).
see photo:
but when I turn the 1 axis pin to the different position, I get about 95-98% of correct position (see photo)
see the cut on axis pin and see the screw position - it is screw on rounded side
on this position gimbal is realy close to correct position.
Why iin this position is straight and in oryginal position is turn to left side ?
I have repair my gimbal on phantom 3 pro. It was damaged after crash. I bought new mainboard (gimbal) and tape to gimbal.
Everything is ok except gimbal stabilization. It stabilize about 90-95%
When I mount 1 axis (axis from mainboard) to oryginal position - gimbal can't stabilize (left right) - it goes to the maximum left position (it is not straight).
see photo:
but when I turn the 1 axis pin to the different position, I get about 95-98% of correct position (see photo)
see the cut on axis pin and see the screw position - it is screw on rounded side
on this position gimbal is realy close to correct position.
Why iin this position is straight and in oryginal position is turn to left side ?