Does it only go all the way up & all the way down and at a high rate?Anyone having a problem, getting dial wheel to work on vision with 3.14 firmware? Please let me know, Thanks!
J Dot
Mines working but not able to stop it dead on when I do .Anyone having a problem, getting dial wheel to work on vision with 3.14 firmware? Please let me know, Thanks!
J Dot
Thought 3.12 was trashed ?It's not me,
A friend, it hooks up and works in PC assistant, but when he power cycles, I auto returns back to basic, and does not work on vision, tx works on flying it but not on camera? We swapped settings, ect. Only difference is I am 3.12 firmware, and he is 3.14. Everything else is the same, mine works, his does not? I told him to re install firmware? I'm out of ideas?
J Dot
Not had any issue with 3.14 that I can tell but did like 3.08 better . Might just be me but seemed I went farther with it .Yeah 3.10 was a disaster! I loved 3.08, upgraded like an idiot, then forced into 3.12 to fix 3.10.... I say screw 3.14! Lol
@Phantompaul is the one having the issues!
J Dot
Am sure he is hitting enter before he leaves that page right ?I told him step by step what to do, from RC ASSISTANT, calibrate sticks and X1, then PC ASSISTANT, calibrate again sticks X1, check upgrade controller, change gimbal switch to ON ( 200mhz ) frequency, all the normal stuff, but when he power cycles the remote, it just jumps back to basic tab? Like it won't stick, or it's not writing the changes to Tx? Either bad firmware install or faulty Tx? I'm out of ideas, but feel bad he can't use such a nice feature!
Sucks!
J Dot
I had that issue way back and finally figured outif I changed anything it didn't stick if I didn't .You know I'm not sure?
J Dot
When I change a # it turns red I believe and goes back black when I hit enter . Thought all had to .Will reply that message to him! Lol
I never had to do that, it just takes!
Weird!
J Dot