- Joined
- Apr 27, 2014
- Messages
- 61
- Reaction score
- 0
Hi All,
Started to use my 3D gimbal this weekend and fired it up all OK. Tested OK on first boot no problem.
On second boot, the gimbal aligned itself and then slowly panned all the way to the right, only stopping once it hit the end stop. This is where the camera would stay until powered off.
On third boot all was OK, and on the 4th the same problem happened.
Tried a firmware update and it has made no difference, still get a very slow pan that I cannot stop.
The gimbal still appears to work OK other than it wont pan because its already at its limit.
Any ideas?
Thanks
Started to use my 3D gimbal this weekend and fired it up all OK. Tested OK on first boot no problem.
On second boot, the gimbal aligned itself and then slowly panned all the way to the right, only stopping once it hit the end stop. This is where the camera would stay until powered off.
On third boot all was OK, and on the 4th the same problem happened.
Tried a firmware update and it has made no difference, still get a very slow pan that I cannot stop.
The gimbal still appears to work OK other than it wont pan because its already at its limit.
Any ideas?
Thanks
