- Joined
- May 18, 2018
- Messages
- 29
- Reaction score
- 4
- Age
- 55
I had a hard landing on the landing legs. One of the legs was bent a little and partially pulled out of the body. I loosened the screw and opened slightly to find that a cable was unplugged. I plugged it back on and reinserted the leg and tightened the screw. The 3nd of the leg where the screw goes into it is dented a little. Other then that there is no visible damage. I also had a gimbal/camera crash protected that goes from leg to leg on it. I'm getting all kinds of errors on the controller (5.5 inch built in) one shows
Overall Status
Camera sensor error
Hardware Malfunction
On the screen that shows your GPS flight map:
Compass error, move aircraft or calibrate compass
Below that:
Forward obsticle sensor is not functioning.
Ambient light sensor is to low
Below that:
Precise fly safe data update
Connect aircraft to update data
Ignore. Update
I'm assuming I need to send it in to have diagnosis done and repairs etc. Would you please tell me of a reputable dji certified repair shop if not in ,nearest savannah, ga.. maybe in Atlanta. I hope not to have to ship to California. I don't have dji care on it, wish I did. I appreciate any advice.
Thanks
Overall Status
Camera sensor error
Hardware Malfunction
On the screen that shows your GPS flight map:
Compass error, move aircraft or calibrate compass
Below that:
Forward obsticle sensor is not functioning.
Ambient light sensor is to low
Below that:
Precise fly safe data update
Connect aircraft to update data
Ignore. Update
I'm assuming I need to send it in to have diagnosis done and repairs etc. Would you please tell me of a reputable dji certified repair shop if not in ,nearest savannah, ga.. maybe in Atlanta. I hope not to have to ship to California. I don't have dji care on it, wish I did. I appreciate any advice.
Thanks