P4P version 2 HDMI

[WetDog]

I was under the impression that the P3 HDMI module fit the P4. However, with the P4P v 2, the base is quite different.

Did DJI pull something again or do I just duct tape it in place? (P3 module top, P4P v2 bottom)

 

[msinger]

I was under the impression that the P3 HDMI module fit the P4.

It does fit all P4 models except the P4P V2.

 

[WetDog]

But of course. Interestingly, the diagram for the controller in the P4Pv2 manual is incorrect - it has an HDMI out whereas the one supplied only has a USB A plug and a micro.

Grrr.

Any suggestions on how to pair it via Occusync. Pretending it's a Mavic Pro doesn't seem to work even with the upgraded firmware.

 

[msinger]

Any suggestions on how to pair it via Occusync.

What exactly are you trying to pair?

 

[WetDog]

P4P version 2 and DJI Googles. I might not have the most upgraded goggle firmware. I have problems with DJI mangling of the English language and interpreted the screen to mean that I was completely updated, not that there is an update. Stand by....

 

[msinger]

The DJI Goggles aren't currently compatible with the Phantom 4 Pro V2. DJI is going to release a firmware update to make them compatible (at some point).

 

[Deleted member 62848]

Ummmmmmm been following with intrest after watching this today,,this from utube clip

,,,should mention I know they used the black racing edition goggles for this but you think it should work normal dji goggles

 

[WetDog]

Interesting where exactly did you find it?\
\

 

[msinger]

should mention I know they used the black racing edition goggles

Yep, the DJI Goggles RE are currently compatible.

 

[Deleted member 62848]

Interesting where exactly did you find it?\
\

Just asked Google and these clips came up