P3 imu error

[sacci]

here, I can say that I tried everything without any result, finally I just have to open this **** imu with the 2 small screws !!
I opened it, I tapped it, I threw it hard against the ground, I tapped it with a hammer to the point of deforming it, but the value always remains the same! Z: -1.45
it's incredible!!!
I found an imu for P3P is it going to work on P3A?
thank you

 

[sacci]

 

[KachemakDiver]

Are you sure you have a P3A? I’ve never seen a P3A that has the IMU screwed on like that.

 

[sacci]

when I say P3A for me it's Phantom 3 Advanced
I am wrong?

 

[KachemakDiver]

Yes, P3A means Phantom 3 Advanced.
I have not seen a IMU attached with 2 screws like in your photo above, on a P3A. They have always been attached to the main board by 4 small screws from underneath on bottom of the board. There is 4 small plastic tabs that holds the IMU sensor in the IMU housing. The housing stays screwed on the circuit board.

 

[sacci]

not most of the imu that I saw on the videos are identical to mine.
it is housed in a small black box in the center of the motherboard, then it is connected to it by a connector.
so if that's really the problem it's easy to change it provided you find a compatible and inexpensive

 

[sacci]

I wonder if this problem is not related to this noise was made. because when it was working I did not have this noise at startup

To view this content we will need your consent to set third party cookies.
For more detailed information, see our cookies page.

Accept third party cookies

 

[sacci]

good evening,
I resolved my problem by changing the imu. now the values are good
thank you