Hi Everyone,
Yesterday I received a used Phantom 2 Vision+ which was supposed to be in a great condition. The quad looks like new, no signs of crashes.. not a single scratch on it. When I power it on, connect to the Phantom network and start the Vision App it shows as connected but only shows wifi signal strengt and extender status. No video from the cam, no GPS (in outside conditions) and the gimbal LED is solid red.
The gimbal centers properly and is controllable from the Tx.
The P2 is recognized from the assistant and I can force-flash updates (already on latest version, but I update anyways.. progress bar goes green and at the end is success). I did a hard reset of the controller and updated again - all well good but no improvement.
Camara is bound and I can ping all the 3 IPs - 192.168.1.1, 192.168.1.2, 192.168.1.10.
Checked cables and there is no visible damage and they sit properly on the board.. I believe..
Red tons of forum topics since yesterday but mostly see others report the same issue and there is no clear answer to it - could be a gimbal-board or cables or software issue..
Already asked in a few older topics but after all decided to start a new topic.
Could someone help please?
Thank you very much!!
Yesterday I received a used Phantom 2 Vision+ which was supposed to be in a great condition. The quad looks like new, no signs of crashes.. not a single scratch on it. When I power it on, connect to the Phantom network and start the Vision App it shows as connected but only shows wifi signal strengt and extender status. No video from the cam, no GPS (in outside conditions) and the gimbal LED is solid red.
The gimbal centers properly and is controllable from the Tx.
The P2 is recognized from the assistant and I can force-flash updates (already on latest version, but I update anyways.. progress bar goes green and at the end is success). I did a hard reset of the controller and updated again - all well good but no improvement.
Camara is bound and I can ping all the 3 IPs - 192.168.1.1, 192.168.1.2, 192.168.1.10.
Checked cables and there is no visible damage and they sit properly on the board.. I believe..
Red tons of forum topics since yesterday but mostly see others report the same issue and there is no clear answer to it - could be a gimbal-board or cables or software issue..
Already asked in a few older topics but after all decided to start a new topic.
Could someone help please?
Thank you very much!!