I was installing an Argtek kit on my P3s and managed to clear the white gunk from the 3 connectors, and disconnect them & get them out of the way. Then I checked what needed to be done to connect the new antennas. On the board where the WiFi antennas go, something wasn't right as I could not find one of the ant sockets. I cleaned the gunk off some more, but was totally baffled, thinking I had goofed. It then struck me that the socket was missing, only the clean solder pads were visible on the board. I am sure I did not remove it with the gunk, the pads are tinned but clean. I am sure there would be some evidence of such butchery if I had been brutal enough to rip a connector off the board. In hindsight, I recall that one lead came away easier than the other. So now I don't know what to do......has anyone else seen or heard of such a situation?
I have a pic that I can put on Facebook if needed. I am open to ideas! But I am grounded until I sort it out! The un-used antenna connector must have been secured by the white stuff, but going nowhere. Beats me!
I have a pic that I can put on Facebook if needed. I am open to ideas! But I am grounded until I sort it out! The un-used antenna connector must have been secured by the white stuff, but going nowhere. Beats me!