- Joined
- Nov 17, 2016
- Messages
- 31
- Reaction score
- 10
- Age
- 75
When I go to calibrate IMU, it stops at 1% and says 'unknown error occurred; recalibration required.' But, when I go to recalibrate it again gets stuck at 1% and displays the same message.
Yes, I crashed, into a tree, near the top, caught by branches. Took me a while to find it, and I had to climb up into the tree and even then use a long loose branch to reach up and slip the branch through the landing skid to get it. No outward appearance of damage. When powering up, the camera/gimbal does its normal routine, the camera works fine. Cables seem intact. But, something is wrong. Any suggestions?? Thanks. -Ken
Yes, I crashed, into a tree, near the top, caught by branches. Took me a while to find it, and I had to climb up into the tree and even then use a long loose branch to reach up and slip the branch through the landing skid to get it. No outward appearance of damage. When powering up, the camera/gimbal does its normal routine, the camera works fine. Cables seem intact. But, something is wrong. Any suggestions?? Thanks. -Ken