goldfinger666 said:
tanasit said:
goldfinger666 said:
Cannot enable IOC Control box (turn on) in Naza assistant advanced "IOC"
I should be able to click into the box and make a check mark appear. What am I doing wrong?
Cheers
How about when you calibrated the TX, did the bars move accordingly and correctly directional-wise?
I really can't say for sure how the bars moved. Will try to pay more attention in the future. Thankyou for your interest...
RE: I really can't say for sure how the bars moved.
From page 17 of NAZA User Manual V2.8
Slides Moving Definition:
T: If you pull the throttle stick to
low position, the Slide will move to the
left and the craft is down,
Moving the Throttle stick
up the slide will move to the
right is craft will lift off the ground;
R: If you move the rudder stick to the
Left the Slide will move to the
left, this is nose left, When you
move the rudder to the
Right the slide move to the
right, this is nose right;
E: If you move the Elevator stick
down the Slide will move to the
left and the craft will move back,
Moving the Elevator Stick
up the Slide will move to the
right and the craft will move Forward (away from you);
A: If you move the Aileron stick to the
left the Slide will move
left and the craft will move to the left,
when you move the Aileron stick to the
Right the slide will move to the
right and the craft will move to the right.
Notices:
1. All slides should become
GREEN when all the sticks are in the middle positions. If slides cannot go back
to center points (become
GREEN ), just click FINISH, then slides will be at center automatically. If still not,
please reboot MC, and do not apply Tx command during the reboot.
2. CSC may not start motors If trims and sub-trims of sticks are not 0!