In the end I decided to replace my P3 Standard Shell/body - (with Pics)

Fileobrother · Mar 3, 2016

Ahh! You have beautiful thighs!

buford · Mar 3, 2016

250Flyer said:
Bump!

You left something out, at least if it had been done at my house anyway....a magnifying glass. lol

250Flyer · Mar 3, 2016

buford said:
You left something out, at least if it had been done at my house anyway....a magnifying glass. lol

For what?

250Flyer · Mar 3, 2016

Fileobrother said:
Ahh! You have beautiful thighs!

Hahahaha.. [emoji5]

buford · Mar 3, 2016

I did some work on my gimbal and ribbon cable. I finally started putting the screws on a piece of duct tape in order, cause a couple of em rolled of the table and hit the dark forest(rug). My eyes are 60. So far away is no good, and too close is no good either, so I bought an electronics mag glass on a pedestal. It's saved my butt a couple a times.

250Flyer · Mar 3, 2016

buford said:
I did some work on my gimbal and ribbon cable. I finally started putting the screws on a piece of duct tape in order, cause a couple of em rolled of the table and hit the dark forest(rug). My eyes are 60. So far away is no good, and too close is no good either, so I bought an electronics mag glass on a pedestal. It's saved my but a couple a times.

Oh I see.

Yeah I made sure everything was in order but did drop a few screws at times...

Some parts are VERY tricky, such as separating the to halves of the shell. You need 10 hands kinda thing because it pops back into place so cardboard helps in between.

buford · Mar 3, 2016

Like I said earlier,....hope I don't have to experience it first hand.

jediflyer · Mar 7, 2017

Wow! Great job!

dan84uk · Mar 7, 2017

cough did someone say hard to disassemble again?

BluWolf · Mar 8, 2017

Too Kewl!

Stew-2 · Mar 8, 2017

buford said:
I finally started putting the screws on a piece of duct tape in order, cause a couple of em rolled of the table and hit the dark forest(rug).

When I used to do laptop repair at a consulting company we would tape all the tiny screws to a sheet of paper and label them as we took them off. For fun a few times we would tape extra screws to someones sheet of paper and watch them scratch their head when trying to figure out where they went, lol. Good times.